Abstract : a cavity is made on both sides of weld bead 文摘:在焊道表面兩側作一空腔。
Weld beads metal and welds - fatigue tests 焊縫金屬和焊接接頭的疲勞試驗法
A cavity is made on both sides of weld bead 在焊道表面兩側作一空腔。
So the shape and the penetration of welding bead will change , result in the lack of the penetration 因此焊縫熔深也發生變動,容易產生熔深不足等缺陷。
Using the heat of welding to vapour water , cooling rates are lowered on the weld bead and heat - affected zone 利用焊接時的加熱使水汽化,不僅使焊道而且使熱影響區的冷卻速度減慢。
As is known to all , the protecting effect of tig welding is fine . the metal in welding bead is pure 眾所周知, tig焊焊縫保護效果好,焊縫金屬純凈,特別適用于焊接易氧化的有色金屬及其合金。
The lack of the penetration of welding bead is a typical defect . it will do great harm to the quality and safety of the welding structure 焊縫熔深不足是焊縫及焊接接頭內部的一個典型缺陷,會給焊接結構的質量及使用安全帶來危害及影響。
The effect of the changes of the wire extension on the penetration of welding bead is analyzed and a project of the controlling to the penetration of welding bead is established in this paper 本文分析了焊接過程中由于干伸長的變化對焊縫熔深的影響,確定了熔深控制方案。
The penetration of welding bead is hard to be checked directly in practice , so the control on the penetration of welding bead is mainly realized by adjusting the related factors 由于焊縫熔深在實時狀態下難以直接檢測,因此,對焊縫熔深的控制主要是通過調節與其相關量來實現的。
Using 304l wire as the cladding material , the experimental results proved that the relationship among welding bead width , welding current and speed could be expressed with a plane in an x - y - z coordinate 對采用304l不銹鋼作為單一熔覆材料的成形試驗研究表明:電流、成形速度與成形軌跡寬度的關系可以采用平面幾何關系表示。